SG8 Precision ionizer gun

Compact design for applications where speed and accuracy are essential.
▪  For the fastest neutralization of electrostatic charges
▪  Suitable for clean room 100
▪  Can also be operated with pure nitrogen (N2)
▪  Fully insulated design to avoid any contact with high voltage
▪  Combined commissioning and control of compressed air and high voltage
▪  Convenient use with footswitch
▪  LED helps to check the operation of the ionization
▪  The air filter, footswitch and gun holder are included
Usage advice
Please be careful not to operate the SG8 Precision Ionizer Gun without incoming air control unit.
It is necessary to use the control unit for optimal operation!
Available accessories: 05-0601-90008 Control unit for Systrone SG8

Properties

▪  Material: Plastic handle
▪  Design: 3 m specially shielded high-voltage, impact-resistant cable
▪  Weight: approx. 4 kg with power supply
▪  Supply voltage: 230 V @ 50 Hz
▪  Current consumption: 0.4 A
▪  Operating temperature: 0 ° C to 50 ° C
▪  Air pressure: 40-80 psi (approx. 2.75 -6.00 bar)
▪  Air connection: Quick connection for 8 mm outer diameter hard compressed air pipe
▪  Air flow: 10 m / s *
▪  Certificate: CE
* Air flow measured at a pressure of 3 kg / cm2.
Electrical

Properties

▪  Charge reduction time: <1.3 s **
▪  Ion balance (Offset): 0 V (± 35 V)
** Measured from a distance of 300 mm with the ME268A Charged Plate from 1000 V to 100 V. This value may vary under different environmental conditions.
Contents of the kit
▪  Ionizer gun
▪  Gun holder
▪  Footswitch
▪  3 m high voltage cable
▪  High voltage transformer
▪ I nstructions for use

Order information

▪  941200 000007 SG8 Precision ionizer gun
Optional accessory
▪  05-0601-90008 Control unit for Systrone SG8
Contents of the set (1-1 pcs)
– adjustable filter unit
– recording unit
Connections
– 1.5 m air duct for connection to SG8
▪  02-0803-10089 SG8-Z2 Controllable stand for Systrone SG8 gun holder
– for flexible placement of the SG8 type pneumatic ionization gun
– Stable metal table holder
– can be screwed to almost any workbenches
– adjustable to any position thanks to its swan neck (330 mm high) (small radius adjustment is avoided)
– the ionizer gun can be easily attached and fastened with a screw